50Mn Steel Bottom Track Rollers 6Y1057 / 8E5034, Track roller CATERPILLAR 325 D DBH 1-UP 117-5046 163-4147 6Y1057 UF194C0E CJ5525 CR5525 A01250C0M00, Friction Welding Bottom Track Roller, Caterpillar Dozer Excavator Track Rollers, Dozer Undercarriage Parts, flanged track roller, bulldozer track rollers, Replacement Cat style Roller Carrier, Undercarriage Parts, OEM Earthmoving Spare Parts Bottom Roller Track […]
CAT 9J3655 Curved Double Bevel Blades Holes 17# 3/4″ Bolt, Motorgrader Bolt On Blade, Low Price Dbc Grader Blades, CATERPILLAR Curved Grader Blade, CAT Genuine Parts Motorgrader Curved Double Bevel Blade, G.E.T Parts Boron Steel Center Blades with 6 holes, Through Hardened Heat Treated Cutting Edges for Motor Grader China Supplier
CAT 9J3655 Curved Double Bevel Blades Specifications:
Part No. 9J3655, 9J-3655
A 152mm Material HB500
B 16mm Diameter 3/4″
C 2438mm Tooth
D Holes 17
• Complete line of curved double bevel (CDB) cutting edges for every make and model
• CDB sizes range from 1/2″ x 6″ for light grading up to heavy-duty 1″ x 8″ CDB section for greater wear life
• Flame-hardened grader cutting edges with surface hardness up to 62 RC, provides max mum wear resistance
• XHD flat grader blades are available in sizes 3/4″ x 8″ through 3″ x 16″ FDB
• Select serrated grader blades are available for frozen or hard packed ground conditions
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, “Dealer Service Tool Catalog” for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g03819062 8D2789, 8D-2789 CAT Edge Cutting Grader Blade
Location of Hydraulic Oil Filter
Illustration 2 g03819066
(1) Type 1 Filter
(2) Type 2 Filter
Open the engine access door. Refer to “Access Doors and Covers”. 8J7782, 8J-7782 CAT Style Motor Grader Edges
Remove the Hydraulic tank filler cap. Refer to “Hydraulic System Oil Level – Check”.
Remove drain plug from bottom of filter housing (canister) to drain oil from the housing. Drain into a suitable container.Note: Use sockets or box end wrenches when servicing the hydraulic oil filter. Do not use an air wrench, open-end wrenches, or an adjustable wrench.
Unscrew canister from filter mounting base. Filter element will come out with housing. Discard the filter element.Note: For Type 2 Filter (2) squeeze the two tabs on filter element to unlatch it from the canister.
Inspect the O-ring or O-rings on the canister or mounting base for damage and replace them if needed.
Clean the inside of the filter mounting base and clean the inside of the canister.
Apply a thin coat of oil to the O-ring on the new filter element and the O-ring or O-rings on the canister or mounting base.
Insert the new filter element in the canister.Note: For Type 2 Filter (2), ensure that the two tabs are latched onto the side of the canister.