7T1631, 7T-1631 Cat General Duty Cutting Edge 16mm

7T1631, 7T-1631 Cat General Duty Cutting Edge 16mm, CATERPILLAR Curved Grader Blade, CAT Genuine Parts Motorgrader Curved Double Bevel Blade, G.E.T Parts Boron Steel Blades with 8 holes, Through Hardened Heat Treated Cutting Edges for Motor Grader China Supplier

7T1631, 7T-1631 Cat General Duty Cutting Edge 16mm Specifications:
Part No. 7T1631, 7T-1631
Weight: 123 pounds 55 kg.
Information:
BEVEL ANGLE 33.5
BOLT HOLE SIZE 18 mm
HOLE SPACING 304.8 mm
LENGTH 2436 mm
NUMBER OF HOLES 10
THICKNESS 15.9 mm
WIDTH 203.2 mm

Cat motor grader cutting edges provide the best balance of abrasion and impact resistance. Both Cat cutting edges and end bits are designed as a balanced system to move more material over a longer period with less downtime. This is accomplished by providing great strength for superior breakage resistance, and by offering maximum wear protection from both bottom and face wear on the cutting edge.

Material: Manganese steel, boron steel
Thickness: 13mm; 16mm; 19mm; 25mm.
Width: 152mm and 203mm.
Length: 4=1219mm; 5=1524mm; 6=1828mm; 7=2133mm; 8=2438mm.
Bolts Dia: 3/4; 5/8
Adaptable for most of graders in market, including Komatsu, Caterpillar, Hitachi, Sumitomo, Kato, Daewoo, etc, also could be designed and produced by clients’ drawing.
Mechanical properties of products could reach international standard after quenching and tempering heat treatment.
Thanks to our high quality raw material and professional heat treatment, our products’ wear life and performance of are 15% ~ 20% higher than most of other similar products in market.
Trade Terms: FOB NINGBO.
Payment Terms: 30% prepaid, T/T at the sight of copy of B/L.

Transmission Direction and Speed Control Lever SchematicProblems with the transmission direction and speed control lever will cause the machine to respond incorrectly to the actions of the lever. Some problems with the transmission direction and speed control lever will cause the transmission to remain in the present speed and direction when a problem is detected. Other problems with the transmission direction and speed control lever will cause the transmission to shift to neutral.
View the status.
Use the Caterpillar Electronic Technician (ET) to view the status “Group 1 Gear Lever Parameters”.
Actuate the transmission direction and speed control lever through all speeds in forward and reverse. Verify the positions on the display of the ET.
Operate the machine in all speeds and all directions. All speeds and all directions may not be available.Expected Result: The fault is NOT present.Results:
OK – The fault is NOT present. Suspect an intermittent fault. STOP.  7T-1627, 7T1627 CAT Grader Curve Cutting Edges
NOT OK – The fault is still present. Note the positions that read incorrectly on the ET. Proceed to Step 2.
Check the harness.  7T-1626, 7T1626 CAT Grader Curve Cutting Edge
Check the harness connectors and the harness from the transmission direction and speed control lever to the power train electronic control module (ECM).
Thoroughly inspect the connectors for the transmission direction and speed control lever and the connectors for the power train ECM.
Visually inspect the harness wiring from the transmission direction and speed control lever to the power train ECM.
Use the ET to view the status “Group 1 Gear Lever Parameters”.  7T-1628, 7T1628 CAT Grader Parts Cutting Edge
Actuate the transmission direction and speed control lever through all speeds in forward and reverse. Verify the positions on the display for the ET.